Roller Shade Measuring Instructions

Roller Shade Measuring Instructions

Use a steel measuring tape.
Measure to the nearest eighth of an inch - don't round your measurements.
On your notes, clearly indicate which measurement is the width and which is the height. It is very common to transpose measurements. Always indicate the WIDTH measurement first, then the HEIGHT last. (W x H)
Remember one very important thing when measuring for an inside mount - Take the ACTUAL WINDOW OPENING SIZE to give to us, our factory will take all the proper allowances for it to fit into that opening.

Before taking any measurements, step back from your window and decide if you want to mount the window treatment inside the window recess, or outside on the wall or molding. We usually recommend an inside mount when possible because it provides a cleaner look. However, an outside mount can make a window appear larger or hide an unattractive window. For an inside mount, the window opening must have enough unobstructed depth to allow mounting. When measuring for an outside mount, be sure to allow for the height of the product's headrail in your measurements.

We will custom make your blinds to the sizes you write on the order. If these sizes are incorrect it is impossible to change the blind, so take your time and double check your measurements.

Click Here for a printable measuring worksheet

Specific Measuring Instructions Below:

For an inside mount:

Measure the opening width at the top. Always measure to the nearest 1/8", and be sure to use a steel tape measure. See tip below.

Measure the height left, right and center, recording the tallest height.

When you specify inside mount,the factory will make your blind slightly narrower than you specified to allow for operating clearance. For sizes up to 72" wide, your material will measure 1 1/8" narrower than the ordered width. For sizes 72" and wider, your material will measure 1 1/4" narrower than the ordered width. The deductions are made so that the blind will not rub or scratch your window frame. Provide the exact window opening width.

For a flush inside mount (the blind completely recessed so that the top of the blind does not project out of the opening) check that you have enough depth.

For an outside mount:

Measure the opening width. If there is room, add at least 3" to the window opening for minimum light gap coverage and maximum privacy.

Measure the opening height. Add a minimum of 2 1/2" in height (3" for 2" horizontal blinds) to allow space for mounting brackets above the opening plus enough overlap for the bottom. If you specify an outside mount, the factory will take a total deduction of 1 1/8"- if your shade is wider than 72", the total deduction will be 1 1/4", so make sure you account for this in your measurements. After determining the measurements that you want the blind to be, hold the tape measure up to your window and visualize what the overall size will look like on that window before proceeding.

Tip: When measuring, don't be surprised if your windows aren't square - many aren't. If they're a little out of square, it probably won't be noticeable. If your window is significantly of square, you might want to consider an Outside Mount to hide the window.

Loading...

Window Blinds

Window Shades

Plantation Shutters

Home : How to Measure : How to Install : About NoBrainerBlinds : Expert Advice : Recommend Us : Privacy Policy : Site Map